Krone Comprima F 155 XC, Original Operating Instructions, Page: 50 / 278

6 Initial operation
6.6 Universal shaft
50
Comprima F 155 XC
Original Operating Instructions 150001050_01_en
6.6.2 Mounting protective cap of universal shaft
RPG000-109
ü
The machine is shut down and safeguarded, refer to page 27 .
„
Take the protective cap (1) out of the storage compartment.
„
Remove the screws (3) and washers (2) pre-assembled on the machine.
„
Push the protective cap (1) over the PTO shaft and mount on the machine using the
screws (3) and disks (2), tightening torques,
refer to page 192 .
6.6.3 Mounting universal shaft bracket
2
1
3
4
RPG000-133
The universal shaft bracket (1) is only required if the drawbar is in the bottom hitching.
The universal shaft bracket (1) is required to support the universal shaft when the machine has
been uncoupled from the tractor.
ü
The machine is shut down and safeguarded, refer to page 27 .
ü
The universal shaft chain (4) and the chain holder have been removed.
„ Take the universal shaft bracket (1) out of the storage compartment.
„
To mount the universal shaft bracket (1), remove the screw connection (3).
„ Clamp the ends of the bolt (2) on both sides in the boreholes of the universal shaft chain
which was removed beforehand.
„
Mount the screw connection (3).
Æ The universal shaft can be deposited with the bottom hitching of the drawbar on the
universal shaft bracket (1),
refer to page 164 .