Krone Comprima F 155 XC, Original Operating Instructions, Page: 176 / 278

17 Settings
17.6 Setting wrapping material brake
176
Comprima F 155 XC
Original Operating Instructions 150001050_01_en
17.6 Setting wrapping material brake
For version with "Net wrapping"
RP000-020
The wrapping material brake is located on the right side of the machine under the storage
compartment.
The spring (2) is mounted in such a way that the brake pad (1) is pressed onto the brake disc
(not shown in the picture). This ensures that the wrapping material brake decelerates the
feeding of the wrapping material to the round bale. If the net was wrapped around the round
bale too loosely or too tightly, the brake force can be set with the nut (4) on the eyelet bolt (3).
Default dimension set by KRONE: X=40 mm
ü
The machine is shut down and safeguarded, refer to page 27 .
ü The roll holder has been swivelled forwards.
„
To increase the brake force, increase the dimension X.
„
To reduce the brake force, reduce the dimension X.
For the "Net and chamber film wrapping" version
6
1
2
X
3
4
5
RP000-608
The wrapping material brake is located on the right side of the machine under the storage
compartment.
The spring (2) is mounted in such a way that the brake pad (1) is pressed onto the brake disc
(not shown in the picture). This ensures that the wrapping material brake decelerates the
feeding of the wrapping material to the round bale.
If the stretching of the film is too strong or too weak or if the net around the round bale has been
tied too strong or too weak, it is possible to increase or reduce the brake force of the wrapping
material brake by means of the nut (5) at the eyelet bolt (3). To check the stretching,
refer to
page 94 .
The pre-set dimension X for net wrapping and chamber film wrapping is X=21 mm .