17
Settings
17.2
Setting the bale diameter
170
Comprima F 155 XC
Original Operating Instructions 150001050_01_en
For "Comfort 1.0" version
Set the baling pressure via the terminal,
17.2
Setting the bale diameter
The bale diameter is equally set on the left and right sides of the machine at the rear.
1
4
3
2
RPG000-062
The smaller the number (2) on the boreholes, the smaller the bale diameter.
The larger the number (2) on the boreholes, the larger the bale diameter.
The lowest borehole may be used only for maintenance purposes and not for operation.
ü
The tailgate is closed.
ü
The bale chamber is empty.
Make the following setting on the right and left sides of the machine in the same way:
Pull the spring cotter pin (3) from the securing pin (4) on the spring tube (1).
Re-insert the securing pin (4) into the required borehole on the spring tube (1) and secure
with the spring cotter pin (3).
Save the set bale diameter on the terminal in the same way,
17.3
Setting the cutting length
1
2
RP000-292
1 Blade group A
2 Blade group B
The cutting length is determined by the number of blades used. The blade groups A and B are
swivelled in or out for this purpose.