Machine description
4
Description of functions of on-board hydraulic system
4.10
BiG Pack 1290 HDP XC
Original Operating Instructions 150000752_01_en
49
4.10
Description of functions of on-board hydraulic system
1
2
3
1
3
4
BPG000-019
For “Comfort 1.0” version
For “Comfort 1.0” version
1
Pressure gauge
3
Pressure limiting valve to set the baling
pressure
2
Valve to loosen the baling flaps
4
Stop cock to loosen the baling flaps
The baling force in the bale channel is controlled by an electronic/hydraulic system. The baling
force is set directly via the terminal from the tractor.
In manual mode,
.
In automatic mode,
.
The baling pressure can be read directly from the display of the terminal. There is another
pressure gauge (1) to read the baling pressure on the pressure limiting valve block.
INFORMATION
In order to maintain the baling pressure in the bale channel when the machine is switched off,
the terminal is only allowed to be switched off when the machine or the flywheel has come to
a complete standstill.
4.11
Functional description of feeding twine for the “double knotter”
version
INFORMATION
When placing the twine rolls in the twine box, make certain that the labeling on the twine roll
can be read. Watch the side that is marked with
“Above”
.
BPG000-020
The large-square baler is equipped with twine boxes on both machine sides. Each twine box is
capable of holding 16 twine rolls. Of these, the twine rolls identified with an “R” are spare rolls.