![Krone Big Pack 1270 XC Original Operating Instructions Download Page 130](http://html1.mh-extra.com/html/krone/big-pack-1270-xc/big-pack-1270-xc_original-operating-instructions_2004793130.webp)
10
KRONE ISOBUS terminal (CCI 200, DELTA)
130
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en
10
KRONE ISOBUS terminal (CCI 200, DELTA)
NOTICE
Penetration of water in the terminal could lead to malfunction. As a result, the machine
can no longer be operated safely.
Protect the terminal from water.
If the machine is not used for an extended period of time (for example in winter), the
terminal must be stored in a dry place.
For mounting and repair jobs, especially for welding jobs on the machine, disconnect the
power supply to the terminal.
INFORMATION
KRONE ISOBUS systems regularly pass the ISOBUS COMPATIBILITY TEST (AEF/DLG/
VDMA test). The operation of this machine at least requires implementation level 3 of
ISOBUS system.
The ISOBUS system is an internationally standardised communications system for agricultural
machines and systems. The designation of the associated series of standards is: ISO 11783.
The agricultural ISOBUS system enables information and data to be exchanged between tractor
and unit of different manufacturers. For this purpose, both the required plug connections and
the signals are standardised which are required for the communication and transmission of
commands. The system also enables machines to be operated with operation units (terminals)
which are already available on the tractor or have been attached e.g. to the tractor cabin. The
relevant information can be found in the technical documents of the operation device or on the
units themselves.
KRONE machines, which have ISOBUS equipment, are coordinated with this system.
1
2
EQG000-024
The electronic equipment of the machine consists essentially of the job computer (1), the
terminal (2) and the control and function elements.
The job computer (1) is located on the front left of the machine under the side hood.
Functions of the job computer (1):
•
Control of actuator system installed on the machine.
•
Transmission of error messages.
•
Evaluation of sensor system.
•
Diagnostics of sensor system and actuator system.
The driver gets information by means of the terminal (2) and settings for the operation of the
machine are performed which are gathered by the job computer and further processed.