Krone 870 HDP, Original Operating Instructions, Page: 461 / 568

Terminal – menus [Medium Plus/Comfort Plus Electronics] 8
Menu 5 "Moisture measurement" 8.11
Supplement to Operating Instructions 150000774_00 _en
BiG Pack 870 HDP, BiG Pack 870 HDP XC
55
Adjusting bale scales
„
Press or until the value (2) corresponds to the weight of the test weight.
„ To save the value, press .
Æ The icon is briefly displayed and the value is saved.
INFORMATION
„ If the limit range is not adequate to adjust the bale scales, contact KRONE customer
service.
Zeroising bale scales
If there is no bale (weight) on the bale scales, but a value (2) is displayed, when the bale chute
is lowered, the sensors B55 "Bale chute at rear" and B56 "Bale chute at front" must be zeroised.
During the zeroising process the acceleration sensor is calibrated.
ü
The bale chute has been lowered refer to page 36 .
ü
There is no bale (weight) on the bale scales.
ü The machine is shut down and safeguarded, refer to page 21 .
„
To zeroise the bale scales, press .
ð
The icon is briefly displayed and the acceleration sensor is calibrated.
8.11 Menu 5 "Moisture measurement"
EQ001-003 / EQ001-006
ü
The menu level is called, refer to page 44 .
„
To open the menu, press .
Æ The display shows the "Moisture measurement" menu.
The "Moisture measurement" menu is divided into the following sub-menus depending on the
machine configuration:
Icon Designation
Menu 5-1 "Alarm message for moisture measurement", refer to
page 56
Menu 5-2 "Correction value for moisture measurement", refer to
page 56