Krone 870 HDP, Original Operating Instructions, Page: 443 / 568

Terminal – machine functions [Medium Plus/Comfort Plus Electronics] 7
Trigger knotter 7.20
Supplement to Operating Instructions 150000774_00 _en
BiG Pack 870 HDP, BiG Pack 870 HDP XC
37
7.20 Trigger knotter
„
Press .
7.21 Raising/lowering blade cassette
Release
„ Press .
ð
The and icons are displayed.
Raising
„ Press and hold .
Lowering
„
Press and hold .
7.22 Setting the target bale channel flap pressure (manual mode)
NOTICE
If an excessively high target bale channel flap pressure is set, the machine may be
mechanically overloaded during baling. This may damage the machine.
The display shows one of the alarm messages "Baling force exceeded" (
L>MAX
,
R>MAX
,
LR>MAX
).
„ To prevent damage to the machine, if the alarm message "Baling force exceeded" occurs
more frequently, reduce the target bale channel flap pressure.
The bale channel flap pressure is entered by the user in manual mode. The pressure is built up
immediately if the PTO shaft is running and the machine is stopped. The pressure display
barely fluctuates on the display. To prevent damage to the machine, the bale channel flap
pressure is reduced to a non-critical value just before the system overloads. After several
seconds, the pressure set by the user is built up again. The bale channel flap pressure is
displayed in
bar or PSI depending on selected system of units.
20
4 cm
38 %
94 / 240 cm
2 / 4
1
2
EQG000-030