Basic safety instructions
4
Danger zones
4.9
Supplement to Operating Instructions 150000774_00 _en
BiG Pack 870 HDP, BiG Pack 870 HDP XC
13
•
Lighting
•
Hydraulics
•
Tyres
•
Universal shaft
If there are doubts about the operational safety of the machine, for example unexpected change
to driving behaviour, visible damage or leaking consumables:
Shut down and safeguard the machine,
.
Immediately eliminate potential causes for damage, for example heavy soiling, or tighten
slack screws.
Determine the cause of damage according to these operating instructions and repair the
damage, if possible, Dummy für Störung-Ursache-Behebung.
In case of damage which may affect operational safety and cannot be repaired on your own
according to these operating instructions: Damage must be repaired or eliminated by
qualified specialist workshop.
Technical limit values
If the technical limit values of the machine are not met, the machine could be damaged. Thus
there is a risk of accidents, serious injuries or death. With regard to safety, it is of special
importance to comply with the following technical limit values:
•
Maximum permitted operating pressure of the hydraulics
•
Maximum permitted drive speed
•
Maximum permitted total weight
•
Maximum permitted axle load/axle loads
•
Maximum permitted drawbar load
•
Maximum permitted axle loads of the tractor
•
Maximum permitted transport height and width
•
Maximum speed
Comply with limit values, .
4.9
Danger zones
Danger zones on tractor and machine
The zone around tractor and machine is a danger zone.
In this danger zone, the hazards are as follows:
•
Tractor and machine may start moving or roll away and overrun persons.
•
Due to unintentional actuation of lifting device, dangerous machine movements may be
triggered.
•
Defective hydraulic or pneumatic lines or lines which are not fastened securely may loosen
or move back back and forth. Hydraulic oil may escape at high pressure and cause serious
injuries to skin or face.
•
An exposed PTO shaft or a damaged or incorrectly mounted universal shaft could capture
clothes and/or body parts and draw them in.
•
When the drive is switched on, machine parts may rotate or swivel.
•
Hydraulically raised machine parts may descend unnoticed and slowly.
If the danger zone is not observed, people may be seriously injured or killed.
Keep people away from the danger zone of the tractor and the machine.
Do not switch on the drives and engine until there is nobody in the danger zone.
The safety clearance is: