Krone 5XL-GD, Operating Instructions Manual

Page: 78 / 126

V - 2
Hydraulic system
5.2 Adjusting the hydraulic system
The operator-friendly hydraulic system of the short-cut
feeder wagon must be adapted to the tractor (see KLW0A-
07) and is designed for continuous circulation.
The system is adapted by adjusting the hydraulic system
screw on the solenoid valve unit.
The unit is located on the end of the wagon at the front
and right under the protective box.
The adjustment is dependent on the
hydraulic system of the tractor and must
be made when the system on the loading
wagon is in a non-pressurised state.
Screw out the system screw (1) to its end stop if:
– the tractor has a standard hydraulic system (pump
constant)
– the tractor has an LS pump and non-activated load-
sensing system
This adjustment is carried out by works
personnel.
Screw in the system screw (1) to its end stop if:
– the tractor has a closed hydraulic system (e.g John
Deere)
– the tractor has an LS pump and a connected signal
cable
The connection (2) for the signal cable is
marked "LS".
6XLD0001
A B
1
2
LS