IV - 33
Comfort Control Unit
4.8 Alarm Message
Information message
If one or several conditions are not met to carry out an
action, the information message will be displayed.
The information message disappears automatically
after a short time.
Alarm Message
If a malfunction occurs in the machine an alarm
message appears in the display and an audio signal is
heard at the same time (rapid-interval horn sound).
Description, possible cause and remedy are shown in
section 5.10.
All functions of the covered menu are
still active.
The softkeys hidden by the alarm
message are deactivated.
Stop audio signal:
• Press the
key for softkey
.
To reset alarm:
• Press the
key for
softkey. The alarm is
reset and the audio signal stops
If the malfunction occurs again, the alarm message will
appear again.
To delete an alarm:
• Keep the
key for
softkey pressed for 5
seconds, the audio signal goes out immediately and
the alarm is deleted.
If the malfunction occurs again, no alarm message will
appear.
The alarm message does not appear when the
malfunction occurs until after the control unit is turned
off and back on.
ZX000026
ZX000025
Summary of Contents for 5XL-GD
