Krone 5XL-GD, Operating Instructions Manual

Page: 109 / 126

A - 3
Appendix
• Park wagon on parking jack.
• Loosen counternut "SW46" (1) , until key can be put
onto piston rod (2)
The threaded spindle must be turned until the distance x
measured between
– the upper edge of the frame and the ground lies
between 1.50 and 1.55 m
So that the adjustment can be made, the
piston (4) of the ram must not be fully
retracted to its end stop.
• Screw up the nut (1) again.
The two rams must be adjusted equally.
If necessary, adjust the position of the ram (1) and its
mounting (2), i.e. by using one of the holes (3) in the tow-
bar frame.
KDW02360
B
A
6XL00005
1
2
3
1
3
2
SW46
6XL00004
4
The towing eye can be mounted in two positions so that
the coupling between the trailer and the towing eye can be
as near to the horizontal as possible to avoid problems
arising from articulating the tow-bar.
Use holes “A” or “B” depending on the height position of
the tractor hitch.
Torque settings for the mounting bolts:
1.450 Nm
A1.1.4 Adjusting the angle of the towing
eye (only for top-mounted attachment)