Kromo Lux 60 EL Operating instructions
Start button
Cycle selected
Rinse temperature
Softener regeneration button
Drain Button
Cycle light
Wash tank temperature
Power button
Regeneration light
Drain light
Power light
To switch on
Make sure that the machine is correctly assembled with all of the filters, drain standpipe,
wash arms and rinse arms in place (top and bottom).Ensure the power is switched on to the
machine, power light the on machine will be red.
Press and hold the power button for 3 seconds, the power light will turn to green and the
machine will start to fill. Within 30 seconds the machine will stop filling and the machine will
start to heat, when the rinse temperature reaches at least 60°C and the wash temperature
reaches 45°C(after approximately 20 minutes). Note
The machine will take longer to heat
on a 13 amp electrical supply.
The dishwasher is ready to use.
The dishwasher is now ready to use.
To set the cycle time press and hold the start button continuously until the desired cycle is
selected then release it.
To start the wash cycle press the start button until the green cycle light comes on (no longer
than 3 seconds), the machine will wash for the selected time, when the wash part of the
cycle has finished the machine will then perform a rinse cycle. When the whole cleaning
cycle has finished the display will read end. You can now unload the machine and reload it
ready for the next wash cycle.
To switch off
At the end of the day press and hold the power button for 3 seconds,
the power light will turn red, remove the drain standpipe, press the
drain button for 3 seconds, the drain light will turn green, then
machine will totally drain down. When the machine is totally drained
and the drain light has gone off, switch the machine off at the wall and
follow the machine cleaning procedure on the reverse side.
