2-port vector network analyzer ARINST VNA-PR1
40
13. RETURN THE DEVICE TO FACTORY SETTINGS
13.1. Turn on the device. While the device is loading, tap and hold the graph image on the screen for
a few seconds (Figure 13.1).
Figure 13.1 - Loading the device after turning on
13.2. The reset menu will appear on the device screen (Figure 13.2).
Figure 13.2 - Menu of device settings reset
Touch and hold the command button for about 2 seconds:
Reset settings
. Resets selected plots, current measurement frequency range and device calibra-
tions. Only the
Factory
calibration remains in the device.
Erase presets.
Removing custom settings from the
Presets
section of the main menu.
Erase traces.
Removing the saved measurement results from the
Traces
section of the main menu.
Recalibrate Screen
. Calibration of the device screen. Executed in cases where the screen takes too
long or does not respond correctly to pressing. Make sure the screen is clean before calibrating. Follow
the instructions in the screen calibration utility.
Custom screen calibrations are applied after the device is loaded.
Factory reset
. Full reset of the device. Only the
Factory
calibration remains.
To exit the reset menu, touch the graph image on the screen.
Summary of Contents for ARINST VNA-PR1
Page 1: ......
