13
EN
Troubleshooting
If your MissionNANO
TM
does not work correctly, follow the trouble shooting guide below. If the fault persists,
contact your dealer.
Symptom
Cause
Action
The LED light on the charging
base does not turn on.
There is no power.
Check the charging base is connected
properly to the charger and the charger
is connected to a suitable power supply.
Green light flashing on the
charging base.
The boundary wire isn’t
connected.
Check that the boundary wire has been
connected correctly to the charging base.
Check there are no breaks in the
boundary wire,especially in the wire ends.
Your MissionNANO
TM
is inside
its territory and the boundary
wire is connected. The error
indication light flashes red.
The boundary wire ends are
clamped incorrectly.
Reverse the boundary wire ends.
MissionNANO
TM
cannot
correctly dock with the
Charging base.
Environmental influences.
Restart MissionNANO
TM
.
Poor connection caused by
debris on the charging strip.
Clean the contact pins located on the
charging base and the charging strip on
MissionNANO
TM
using a cloth.
MissionNANO
TM
runs
outside the boundary wire.
MissionNANO
TM
does not mow
an area within a boundary wire
zone. MissionNANO
TM
reverses
or rotates erratically near the
boundary wire.
The boundary wire of another
MissionNANO
TM
or another
branded robotic mower is
positioned too closely.
Ensure your MissionNANO
TM
boundary
wire has at least 1m of spacing between
the neighboring boundary wire.
The boundary wire has been
installed with acute angles.
Check the boundary wire to ensure the
angles are smooth.
In wet conditions, the boundary
wire electric signal may leak
where wire has been joined or
repaired.
Check boundary wire joints. Insulate to
provide a fully waterproof connection.
There is boundary wire electric
signal leakage due to broken
insulation.
Repair damaged boundary wire
insulation with insulation tape.
The cutting area is larger than
the allowable cutting area for
MissionNANO
TM
.
Decrease the cutting area.
MissionNANO
TM
exits the
boundary wire due to high
speed when going down a hill.
The boundary wire is placed on
a slope steeper than 17% (10°).
Reposition the boundary wire away from
slopes that are steeper than 17% (10°).
Environmental protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
