KREBS Tex-2, Operating Instructions Manual

Page: 13 / 32

Fault finding
Fault Cause and remedy
Spraying jet is irregular Nozzle clogged
(Clean nozzle or send to manufacturer)
Irregular operating sound a) Incorrect setting of setting screw
(See Preparation)
b) Insufficient fluid in container
No suction a) Suction tube loose
b) Setting screw turned too far in clockwise direction.
(See Preparation)
Unit does not run with normal a) Piston seized in cylinder. You have sprayed an
operating sound but only unsuitable medium. Should cylinder piston be too
hums quietly. badly damaged, the complete pump assembly must
be replaced.
b) Nozzle head is completely clogged.
(Clean or send to manufacturer)
c) Pump weared out (replace)
Ring marks remain in material Wrong jet setting, incorrect operation, drying not carried
out properly.
Threads are displaced Jet is too concentrated, distance between fabric is not
enough, angle of spraying is incorrect. (See Tips)
VARIA Nozzle leaks Tighten nozzle head and threaded holder against each
other.
Nozzle clogged Clean nozzle head and swirl head as instructed.
Product liability
No liability is accepted for damage caused directly or indirectly by the use and spraying
of products.
6 Months Guarantee
The guarantee covers the remedying of all faults, without cost to the customer, arising from
faulty manufacture of materials. This guarantee excludes damage caused by ingress of dirt,
insufficient and/or incorrect maintenance.
THEO KREBS LTD
13