36
in the receiver may overheat, spill or even explode. Do not install batteries into the
device that have been exposed to the sun, moisture, high temperatures or shocks.
Only batteries of the same type and manufacturer should be installed. Do not install
new and used batteries. The power supply module G60-ZB90 can be optionally
purchased with the set. This module is powered by four 1.5V AA batteries and should
be connected directly to the receiver where the AC adapter is connected. The
additional power module eliminates the need for a battery in the receiver. Optionally,
the customer can buy a cable connecting the chopper block with the receiver, equipped
with a switch, to the gas control system. The switch additionally protects the system
against uncontrolled gas flow through the controller.
Installation of the device
Before commencing the installation, the elements of the gas control system must be
protected against dirt. Installation of the fireplace should be made of non-combustible
materials (this also applies to the floor and ceiling) in accordance with applicable
building regulations. If the fireplace is powered by natural gas, the exhaust grille should
be placed under the ceiling. Liquid propane gas supply - butane requires the installer
to build a built-in exhaust grille at the floor, above ground level.
Installation of decorative elements
Attention!!!
The manufacturer recommends using decorative elements optionally supplied
with the device. The Kratki.pl Marek Bal company is not liable for damages
resulting from the use of decorations other than those recommended.
Depending on the user's preferences, the combustion chamber can be lined with one
of several available sets of decorative elements. Decorative elements are made of non-
combustible material. It is forbidden to place flammable elements in the device.
To mount decorative elements, it is necessary to remove the front window. The
elements should be arranged in such a way that they do not cover the control flame
and the main burner outlet openings, otherwise it may cause the fireplace to
malfunction. The main burner of the fireplace is equipped with spacers to facilitate the
correct arrangement of decorative elements. The distribution of elements in the
combustion chamber of the device should allow free flow of air around the main burner
and control flame. Ceramic components should not adhere to the glass as it may
damage it. The correct and incorrect arrangement of decorative elements is presented
below.
