INSTRUKCJ
A MONTAŻU I OBSŁUGI –
SERIA LEO wersja 1.0
15
or curtains. Due to the possibility of ignition, it is forbidden to dry clothes, towels, etc.
near the gas insert. The fireplace should be installed on a stable non-flammable
surface. The gas insert is equipped with special feet with adjustable height and two
adjustable mounting brackets enabling the device to be attached to the wall. It is
forbidden to install the gas insert on the back or side. Only vertical mounting is allowed.
Ventilation grates in the housing
Installation of the device is only allowed in a non-flammable housing as shown in the
diagrams with a 60 mm spacing at the back and sides of the device, only where there
is no glazing. In the case of side glazing, it is allowed to mount the building walls to the
front of the device's cover. To adapt to different thicknesses and finishes of the furnace
materials, follow the instructions below.
Buildings and other decorative elements of the body can be installed on the surface of
the device, provided that the minimum spacing between the device and non-
combustible material is kept in accordance with the requirements contained in the
instructions and provided that they are non-combustible. The material surrounding the
device (body) must not transfer weight to the device or be connected to the device in
any way. They must not cover the removable glass panel or control system in any way,
or hinder their removal or service.
The total thickness of the non-combustible cladding must be determined to allow the
surface to be flush with the front of the device. The total thickness of the cladding can
be from 15 mm to 30 mm.
WARNING:
You should always consider installation very carefully before taking any
steps to install the device, since there must be no flammable materials at a distance of
at least 100 cm from this fireplace.
