Kramer WP-20CT, User Manual

Page: 25 / 47

Kramer Electronics Ltd.
WP-20CT
– Operating and Controlling WP-20CT
23
Setting Auto Standby Delay
WP-20CT enables you to set the delay time (up to 900min, never 0; default = 30min) before
the device goes into standby mode after a period of no device activity.
To set auto standby delay time:
1. Go to the Device Settings > General page ( Figure 14 ).
2. Under Auto Standby, click ENABLE .
3. Under No Device Activity Timeout, set the delay time.
4. Click Save .
Auto standby delay time is set.
To manually enter or exit standby mode where the 5V signal is turned off, under Standby
Status, click
ENTER / EXIT .
Exporting and Importing a Configuration File
WP-20CT enables you to export a configuration file that records all current device settings
except the switching configuration. This file can then be imported to the same or different
WP-20CT device to load the recorded settings.
To export a configuration file of the current device settings:
1. Go to the Device Settings > General page ( Figure 14 ).
2. Under Global System Settings, click Export .
3. Select the location on your computer to save the configuration file and click Save .
The configuration file is exported and saved.
To import a configuration file of the current device settings:
1. Go to the Device Settings > General page ( Figure 14 ).
2. Under Global System Settings, click Import .
3. Select the relevant configuration file and click Save .
The configuration file is imported and the device restarts with the settings from the
configuration file.