Kramer Electronics Ltd.
WP-20CT
– Operating and Controlling WP-20CT
20
Configuring AV Settings
Figure 12: AV Settings > AV Tab
WP-20CT
enables you to configure the following general settings on the AV Settings > AV
tab:
•
Label
– Change the name of an input or output as it appears on the Main (switching)
page and EDID Management page.
•
HDCP
– For the inputs, select the
Yes
(default)
/No
switch to enable/disable HDCP for
that input. For the output, select
Always On
keep HDCP enabled or
Follow Input
(default) to define the output HDCP setting according to the active input.
•
Device Color Depth
–
Follow Output
(default)
or
Force 8 bit
.
•
Force RGB on Output
–
Enable
or
Disable
(default).
•
Device Auto-Unmute on volume change
– When enabled
(default), changing the volume
will unmute the device.
•
Auto Sleep Delay
– When no input signal is detected, the device automatically goes into
sleep mode. When this setting is enabled
(default), it delays sleep mode for an amount
of time specified in the next setting.
•
No input signal
– Set the number of seconds (30 to 60,000 seconds; default = 900
seconds) after there is no signal detected, until the device goes into sleep mode. Click
SET TIMEOUT
after defining this setting.
