Kramer Electronics Ltd.
VS-88H2A
– Operating VS-88H2A via Front Panel Buttons
25
▪
HDCP disabled (off): IN button is off.
2. Press one or more input buttons to change their status.
The
LOCK
button flashes.
3. Press
LOCK
to save changes and exit the HDCP mode.
HDVP status is changed.
Copying EDID
You can copy the EDID to an input from a connected output or use the default EDID.
To copy the EDID from a connected output:
1. Press and hold
EDID
and
STO
until both buttons illuminate.
VS-88H2A
enters the EDID mode and the 7-segment display shows the current EDID
status:
On the front panel button:
•
Both input and output buttons are dark.
On the 7-segment display:
•
“
d
” under an output number indicates that the input port is set to the default EDID.
•
“
L
” under an output number indicates that the EDID was uploaded externally from a
file via Web page.
•
A digit under an output number indicates the output from which the EDID was
copied.
2. Press one or more input buttons (or
ALL
).
The 7-segment display LEDs of the selected inputs flash.
3. Press an output button (with a connected display) from which to copy the EDID.
4. Press
EDID
.
Wait for about 5 seconds for the device to copy the EDID from the connected display.
EDID is copied from a connected output.
To copy the default EDID:
1. Press and hold
EDID
and
STO
until both buttons illuminate.
VS-88H2A
enters the EDID mode and the 7-segment display shows the current EDID
status.
2. Press one or more input buttons (or
ALL
).
The 7-segment display LEDs of the selected inputs flash.
3. Press a disconnected output button.
4. Press
EDID
.
Wait for about 5 seconds for the device to copy the default EDID to the selected inputs.
EDID is copied from the default.
