Kramer Electronics Ltd.
VS-88DT
– Operating the VS-88DT
13
Operating the VS-88DT
When the
VS-88DT
is powered on, the following is displayed briefly on the LCD display:
KRAMER ELEC
8X8 HDMI/HDBT Matrix
Following the self-test the current switching configuration is displayed, an example of which is
shown below. The top row indicates the output port and the bottom row indicates which input
port is switched to the output port displayed directly above it. An input port showing 0 (zero)
indicates that the output port has no input switched to it.
O: 1 2 3 4 5 6 7 8
I: 3 0 1 2 4 5 2 8
Note
: If there is no button activity during any procedure for approximately 30 seconds, the
procedure is aborted and the display reverts back to the Input/Output display.
Switching Inputs to Outputs
You can switch:
•
Individual inputs to individual outputs
•
One input to all outputs
To switch an output to an input, (for example, Input 7 to Output 3):
1. Press Out 3.
The Output button lights red.
2. Press In 7.
The Input button lights red and the switch is performed.
To switch one input to all outputs, (for example, Input 2 to all outputs)
:
1. Press All.
The All button lights red.
2. Press In 2.
The Input 2 button lights and Input 2 is switched to all outputs.