Kramer VS-6464DN-EM, User Manual

Page: 13 / 94

Kramer Electronics Ltd.
VS-6464DN-EM
– Connecting the VS-6464DN-EM
11
Connecting the VS-6464DN-EM
Always switch off the power to each device before connecting it to your VS-6464DN-EM . After
connecting your VS-6464DN-EM , connect its power and then switch on the power to each
device.
You do not have to connect all the inputs and outputs, connect only those that are required.
In the following example, only two inputs and two outputs are connected.
The configuration of DVI input/output cards shown in Figure 4 is merely a sample
representation and different input / output cards may be mixed as required (for limitations, see
Port Numbering on page 12 ). Exactly the same principles apply to installations using other
card types.
To connect the VS-6464DN-EM , as illustrated in the example in Figure 4 , do the following:
1. Connect up to 64 DVI video sources (for example, computer graphics sources).
2. Connect up to 64 DVI video acceptors, (for example, a plasma display and DVI LCD
display).
3. If required, connect a PC or remote controller to the RS-232 port (see Connecting to the
VS-6464DN-EM via RS-232 on page 14 ) and/or the Ethernet port (see Connecting to the
VS-6464DN-EM via Ethernet on page 14 ).
4. Connect the power cord.
5. If necessary, review and set the system configuration using the Menu (see Using the
Configuration Menus on page 22 ).
Given an input signal that is HDCP encoded, the VS-6464DN-EM outputs a signal only if the
output port to which it is switched supports HDCP.