Kramer VP-554X, User Manual

Page: 44 / 89

Kramer Electronics Ltd.
VP-554X
– Using Embedded Web pages
42
4. Define the UDP and TCP ports.
•
After changing the IP address, reload the web page with the new IP address.
•
After changing the subnet mask turn the
VP-554X
power off and then on again.
•
If DHCP is checked, you need to reload the web page with the new IP address.
Performing a Firmware Upgrade
To perform firmware upgrade:
1. In the Navigation pane, click Device Settings . The Device Settings page appears
( Figure 24 ).
2. Click Choose File . A browse window appears.
3. Select the new firmware file, click Upgrade and follow the instructions on-screen.
The new firmware reloads.
Performing a Factory Reset
To reset the device to its factory default values:
1. In the Navigation pane, click Device Settings .
The Device Settings page appears ( Figure 24 ).
2. Click Soft Factory Reset .
The following window appears:
Figure 25: Device Settings Page
– Factory Reset
3. Click OK to start factory reset and follow the instructions on-screen.
The device resets to its default parameters.
Routing the USB Switcher
Control the USB switcher via the USB Routing page either by switching one of the four USB
inputs to the USB output or by tying each USB input to one of the video inputs so that when a
video input is switched to output 1, the USB input that is tied to it switches to the USB output
at the same time.
This section enables performing the following actions:
•
Tying a USB Input to a Video Input on page 43 .
•
Routing the USB Switcher on page 43 .