Kramer Electronics Ltd.
VP-554X
– Operating and Controlling VP-554X
20
Setting Audio Output Monitor Out and Speaker Parameters
VP-554X
enables defining the monitor output and speaker parameters.
The AUDIO OUTPUT menu appears in the OSD output 1 menu only.
To set the audio parameters:
1. On the front panel press
MENU
. The menu appears.
2. Select
ADVANCED
and then
AUDIO
.
3. Select an audio parameter from the list below and adjust as needed.
4. For each adjusted parameter, press
ENTER
.
Menu Item
Function
SOURCE
Select any of the following audio sources: HDMI (1 to 6), HDBT (1to 4),
ANALOG (1 to 8), MIC1, MIC2, MIC 1+2, FOLLOW VIDEO (default).
EMBEDDED HDMI (1 to 6) Select EMBEDDED, ANALOG, or AUTOMATIC (default).
EMBEDDED selects the embedded HDMI audio source; ANALOG
selects the analog audio corresponding to the input; and AUTOMATIC
(default) selects the embedded audio when an HDMI source is detected,
or the analog audio when a DVI input is detected.
HDBT (1 to 4)
SPEAKER VOLUME
Set the Speaker output volume.
0 to 100 (Default: 80).
LINE VOLUME
Set the monitor line volume.
0 to 100 (Default: 80).
SPEAKER HARDSTOP
Set speaker volume hard stop. (Use this feature to limit the maximum
speaker volume level).
0~100 (Default: 80).
LINE HARDSTOP
Set the monitor hard stop. (Use this feature to limit the maximum volume
level on the line output).
0~100 (Default: 80).
SPEAKER MUTE
Mute the speaker audio.
OFF/ ON (Default: OFF).
LINE MUTE
Mute the monitor audio.
OFF/ ON (Default: OFF).
AUDIO DELAY
OFF/ 10ms/ 20ms/ 30ms/ 40ms/ 50ms (Default: OFF).
MIXER MODE
OFF/ MIXER/ TALKOVER (Default: OFF).
MIXER LEVEL
0~100 (Default: 100).
TALKOVER
When Mic Mode is set to Talkover (see
), set
the following:
Depth [%]
Set the depth value to determine the decrease of the audio level during
microphone takeover (press + to further decrease the talkover audio
output level; press
– to lessen the talkover output audio decrease level).
Trigger [dB]
Set the trigger value to determine the microphone threshold level that
triggers the audio output level decrease.
Attack Time
Set the attack time to set the
transition
time of the audio level reduction
after the signal rises above the threshold level.
Hold Time
Set the hold time to define the time-period talkover remains active
although the signal falls below the threshold level (for a short period of
time).
Release Time
Set the release time to define the transition time for the audio level to
return from its reduced level to its normal level after the Hold Time
period.
