Kramer Electronics Ltd.
VP-554X
– Connecting VP-554X
11
Connecting a Balanced/Unbalanced Stereo Audio
Source to the Input
The following are the pinouts for connecting a balanced or unbalanced stereo audio source to
the balanced input:
Figure 6: Connecting a Balanced Stereo Audio
Source to the Balanced Input
Figure 7: Connecting an Unbalanced Stereo Audio
Source to the Balanced Input
Connecting to VP-554X via RS-232
You can connect to
VP-554X
via an RS-232 connection
using, for example, a PC.
VP-554X
features an RS-232 3-pin terminal block connector allowing the RS-232 to control
VP-554X
.
Connect the RS-232 terminal block on the rear panel of
VP-554X
to
a PC/controller, as
follows:
From the RS-232 9-pin D-sub serial port connect:
•
Pin 2 to the TX pin on the
VP-554X
RS-232 terminal block
•
Pin 3 to the RX pin on the
VP-554X
RS-232 terminal block
•
Pin 5 to the G pin on the
VP-554X
RS-232 terminal block
RS-232 Device
VP-554X
Wiring RJ-45 Connectors
This section defines the TP pinout, using a straight pin-to-pin cable with RJ-45 connectors.
For HDBT cables, it is recommended that the cable ground shielding be connected/soldered
to the connector shield.
EIA /TIA 568B
PIN Wire Color
1
Orange / White
2
Orange
3
Green / White
4
Blue
5
Blue / White
6
Green
7
Brown / White
8
Brown
13
