Kramer VP-427UHD, Quick Start Manual

Page: 1 / 2

VP-427UHD Quick Start
P/N: 2 9 0 0 - 3 0 1 1 5 6 QS
Rev: 3
Scan for full manual
VP-427UHD Quick Start Guide
This guide helps you install and use your VP-427UHD for the first time.
Go to www.kramerav.com/downloads/VP-427UHD to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check
what’s in the box
VP-427UHD HDMI/HDBT Receiver/Switcher/Scaler
1 Bracket set
1 Quick start guide
1 Power adapter and cord 4 Rubber feet
Step 2: Get to know your VP-427UHD
# Feature Function
1 IN LED Lights green when the HDMI input is selected, blue when HDBT is selected and flashes if no
input signal is detected.
2 HDBT/HDMI Button Press to select the remote HDBT or the local HDMI source.
3 HDMI
™ OUT Status LED
Lights green when an HDMI acceptor is connected.
4 HDBT LINK status LED Lights green when an HDBT link between a transmitter and the receiver is successfully
established and is active.
5 ON LED Lights green when the unit is powered from the local 12V DC source and lights blue when
receiving PoE via HDBT.
6 MENU Button Press to enter the OSD menu. When in OSD, press to exit one level up.
7 ENTER Button When not in OSD, press ENTER to view the input status on the display (the selected input,
resolution and frame rate, HDCP state and aspect ratio).
When in OSD, press to select and carry out a menu item or to accept a parameter value.
Press and hold together with the
– or + to increase the speed of parameter-decrement or
increment, respectively.
Press and hold for about 3 seconds to reset a menu parameter to its default values.
8
– Button
Press and hold together with the + button to reset the output resolution to 1080p (default).
In OSD, press to move back through the menu list or to decrement a parameter value (or
press together with ENTER to speed up parameter decrement).
9 + (also Freeze) Button Press and hold together with the
– button to reset the output resolution to 1080p (default).
When not in OSD: press to freeze the image;
In OSD, press to move forward through the sub-menu list or to increment the parameter
value (or press together with ENTER to speed up parameter increment).
10 FREEZE LED Lights green when freezing the image.
11 HDBT IN RJ-45 Connector Connects to an HDBaseT transmitter.
12 HDMI IN Connector Connect to an HDMI source.
13 HDMI OUT Connector Connects to an HDMI acceptor.