TP-789Rxr Quick Start (P/N: 2900-301008QS REV 1)
P/N:
2 9 0 0 - 3 0 1 0 0 8 QS
Rev:
1
Scan for full manual
TP-789Rxr Quick Start Guide
This guide helps you install and use your
TP-789Rxr
for the first time.
www.kramerav.com/downloads/TP-789Rxr
to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check w
hat’s in the box
TP-789Rxr
HDMI Line Receiver
4 Rubber feet
1 Quick start guide
1 Power adapter and cord
1 Bracket set
Step 2: Get to know your TP-789Rxr
#
Feature
Function
1
SETUP DIP-switches
Set the operation DIP-switches.
2
IN LED
Lights green when an active, far-end source device input signal is
detected.
3
OUT LED
Lights green when an active sink (acceptor) output signal is detected
via the HDBT link.
4
LINK LED
Lights green when an HDBT link is established with the HDBT
transmitter.
5
POE FEEDER LED
Lights green when the device is feeding PoE power to the HDBT
connected transmitter.
6
ON LED
Lights green when the device receives power either from the power
supply unit or by PoE.
7
HDBT IN RJ-45 Connector
Connect to the RJ-45 HDBT OUT connector on a transmitter (for
example,
WP-20
,
TP-780Txr
).
8
HDMI OUT Connector
Connect to an HDMI acceptor.
9
ETHERNET RJ-45 Connector
For LAN extension to the transmitter.
10 IR 3.5mm Mini Jack Connector
Connect to an external infrared emitter / sensor.
11 RS-232 (G, Rx, Tx) 3-pin Terminal Block Connector
Connects to an RS-232 port for serial link extension to a transmitter.
12 48V DC Power Terminal Block Connector
If
TP-789Rxr
provides
PoE, connect it to the Kramer power supply.
If it accepts PoE, no power connection is needed.
