KRAMER
OWB-1G/65/EU Quick Start
This guide helps you install and use your product for the first time. For more detailed information, g
or scan the QR code on the left.
o to
Step 1: Check what’s in the box
1 gang metal frame for two inserts
Wall mounting kit
The
OWB-1G/65/EU
On-wall Box
Step 2: Overview
Installing the Inserts
To install the inserts onto the
OWB-1G/65/EU
, do the following:
Connect the cable ports to the rear side of the insert(s).
3. Use 2 screws to attach the metal insert frame to the
OWB-1G/65/EU
.
1. Mount the inserts onto the supplied metal frame (inserts are
not included
and can be purchased separately).
2.
Step 3: Installing the OWB-1G/65/EU
OWB-1G/65/EU Quick Start (P/N: 2900-300589QS REV 3)
2 9 0 0 - 3 0 0 5 8 9 QS
3
To mount the
OWB-1G/65/EU
to a wall or other surface, do the following:
If you want to feed the cables to the
OWB-1G/65/EU
from any of the four sides, carefully break the knock-off holes where appropriate
(knock-off holes are shown as gray dotted lines in the illustrations below).
Feed the cables from the rear/sides of the
OWB-1G/65/EU
out through the front.
Hold the
OWB-1G/65/EU
in position against the wall or surface on which it is to be mounted, taking care that the
OWB-1G/65/EU
is
level, and attach it using the wall mounting kit.
You can install either two inserts or a 1 gang European wall plate.
The
OWB-1G/65/EU
is a white plastic wall-box for mounting two Kramer inserts or a 1 gang European wall plate. The box is mounted
on the wall for applications where in-wall installation is not possible.
OWB-1G/65/EU
The
is 65mm deep allowing sufficient space to prevent damage to connectors (such as HDMI connectors) when
connecting the rear side of the insert or wall plate.
P/N:
Rev: