Kramer Electronics Ltd.
KDS-EN7, KDS-DEC7
– Using KDS-EN7 Embedded Web Pages
39
Configuring CEC Settings
KDS-EN7
sends CEC commands from a control system, connected by LAN, via the
KDS-
EN7
built-in control gateway, to control CEC enabled devices that are connected to the
KDS-
EN7
HDMI output and input.
To set CEC Gateway:
1. In the Navigation pane, click
Control
. The Control>Settings page appears.
Figure 29: Control > Settings Page
– CEC Settings
2. Click
Enable
to enable CEC gateway or click
Disable
.
3. Select the HDMI port from the drop-down list to which CEC commands are sent:
▪
HDMI Input (HDMI IN).
▪
HDMI Loop Through (HDMI OUT).
4. Enter the CEC command.
Use hex format for the CEC command, up to 32 hex digits.
5. Click
SEND
.
6. View the CEC-enabled device response.
CEC Gateway is configured.