18
KADS-100/KADS-1/KADS-2 - Operating the KADS-100
To set up a channel
:
1. Press Enter.
The display shows the first entry of the menu.
2. Use the rotary knob to move down the menu to Channel Setup.
3. Press Enter.
The display shows the Channel ID selection.
4. Use the rotary knob to move up or down the channel list. Press Enter when
the required channel ID is displayed.
The Channel properties menu is displayed.
5. Press Enter or use the rotary knob to move up and down the channel
properties. Repeat until the required properties have been set.
6. Press Esc repeatedly until you exit the menu system.
8.1.2
Selecting a Speaker to Control
Note
: If no speaker is selected, then the last speaker that was selected is
controlled. If no speaker was previously selected then speaker 1 is controlled by
default.
To select a speaker to control, use either of the following methods:
1. Press the required Keypad button on the front panel.
The selected Speaker button lights red and the LED on the speaker lights.
2. Enter the number of the speaker to control using the Keypad 1 to 9 and 0
buttons, for example, press 2 and 8 for speaker 28.
The selected speaker number is displayed on the LCD.
3. Press the Enter button.
Use the menu options to configure the speaker, (see
Section
—OR—
1. Press Enter.
