Kramer Electronics Ltd.
K-Cam4K
– Operating and Controlling K-Cam4K
11
Assigning up to 4 K-Cam4K Units to the IR Remote Controller
You can use one IR remote controller to control several cameras. To do so, you need to
assign each device to the remote controller via IR learning.
To assign a device to the IR remote controller:
1. Turn the camera on.
2. Point the IR controller towards the front panel of the camera and press the following
keys:
▪
To assign Camera 1
– Press
*
,
#
and
F1
simultaneously to set IR address to
"CAMERA SELECT 1".
▪
To assign Camera 2
– Press
*
,
#
and
F2
simultaneously to set IR address to
"CAMERA SELECT 2".
▪
To assign Camera 3
– Press
*
,
#
and
F3
simultaneously to set IR address to
"CAMERA SELECT 3".
▪
To assign Camera 4
– Press
*
,
#
and
F4
simultaneously to set IR address to
"CAMERA SELECT 4".
When assigning a camera to the remote, make sure you point directly to that camera and
check that the other cameras in the area are powered down.
Cameras are assigned to IR remote controller.
Freezing an Image
You can freeze/unfreeze an image manually:
•
To freeze an image, press
F4
on the remote controller. The image freezes and the
display shows “Freeze” on the top left side for 5 seconds.
•
To Unfreeze the image, press
F4
(once again) on the remote controller. The image
unfreezes and the display shows “Unfreeze” on the top left side for 5 seconds.
Shortcut Keys
Use the following shortcut keys to set the following:
•
*+
#
+1
: OSD default (English).
•
*+
#
+3
: OSD default (Chinese).
•
*+
#
+4
: Display current IP address.
•
*+
#
+6
: Quickly recover the default.
•
*+
#
+8
: View the camera version.
•
*+
#
+9
: Quickly set up inversion.
•
*+
#
+MANUAL
: Restore default IP address.