FC-202NET - Connecting the FC-202NET
7
To connect the
FC-202NET
as illustrated in the example in
1. Connect a balanced audio source, (for example, a microphone) to the 3-pin
Input 1 terminal block.
2. Connect a balanced audio source, (for example, a multimedia player) to the
3-pin Input 2 terminal block.
3. Connect a Dante audio network source via the network to the Dante RJ-45
connector.
4. Connect the Output 2 3-pin terminal block to the first balanced, line-level
audio acceptor, (for example, a recording device).
5. Connect the Output 1 3-pin terminal block to the second balanced, audio
acceptor, (for example, an amplified speaker).
6. Connect the power adapter to the
FC-202NET
and plug the power adapter
into the mains power supply.
5.2
Connecting the Inputs
Your
FC-202NET
is provided with a 3-pin terminal block for each input channel.
This connector can accept either a balanced or an unbalanced connection,
however, some modifications must be made for an unbalanced connection. See
the next two sections for instructions on connecting the NetAV I/O 2x2 to its input
source.
5.2.1
Connecting Balanced Inputs
When using a balanced input source and connector, you must ensure that the hot,
cold, and ground pins of the connector are matched up to the +,
–, and ground
pins of the
FC-202NET
terminal block connector respectively. The following
diagrams illustrate how to connect standard XLR and 6.5mm phone jack.