Kramer Electronics Ltd.
DSP
‑
1
– Using the
Web Pages
13
2. Set DHCP
to
ON
or
OFF
.
3. If DHCP is set to
OFF
, change any of the parameters (IP Address, Netmask and/or
Gateway), if required.
4. Click
Set
.
•
After changing the IP address, reload the web page with the new IP address.
•
After changing the Mask address you need to restart the
DSP
‑
1
.
•
If DHCP is checked, reload the web page with the new IP address.
5. Set the UDP and TCP port numbers and click
Set
.
Saving and Loading Settings
To save a configuration:
1. In the Navigation pane, click
Device Settings
.
The Device Settings page appears (see
2. Click
Save
. The following message appears:
“Configuration file is ready, right-click here to download”.
3. Right-click the link (
right-click here
) and click
Save link as
.
The configuration is downloaded to your PC.
To load a configuration:
1. In the Navigation pane, click
Device Settings
.
The Device Settings page appears (see
2. Click
Load
and browse for the configuration file.
3. Click
Open
.
The configuration loads (this process may take a few minutes to complete).
A message indicating that the configuration uploaded successfully appears.
Performing a Factory Reset
To reset the device to its factory default values:
1. In the Navigation pane, click
Device Settings
.
The Device Settings page appears (see
2. Click
Factory reset
.
A confirmation warning message appears.
3. Click
OK
to start factory reset and follow the instructions on-screen.