TP-580RA
Quick Start
P/N: 2 9 0 0 - 3 0 0 8 6 3 QS
Rev: 4
Scan for full manual
TP-580RA Quick Start Guide
This guide helps you install and use your
TP-580RA
for the first time.
www.kramerav.com/downloads/TP-580RA
to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check
what’s in the box
TP-580RA
HDMI Line Receiver
4 Rubber feet
1 Power adapter and cord
1 Quick start guide
Step 2: Get to know your TP-580RA
#
Feature
Function
1
PROG Micro USB
Port
Connect to a PC to perform firmware upgrades (via K-Upload) and work with the EDID
Designer. K-Upload and EDID Designer can be downloaded from our Web site at:
2
SET UP DIP-switches
Used to set the device behavior.
3
IN
LED
Lights green when an active far-
end source HDMI™ input signal is detected via the HDBaseT
link (an HDMI signal is detected from a source device connected to the HDBaseT transmitter
that is connected to this input).
4
OUT LED
Lights green when a signal is detected on the HDMI output from an active device.
5
LINK
LED
Lights green when a link is established between the
TP-580RA
and the HDBaseT transmitter.
6
ON
LED
Lights green when the device receives power.
7
HDBT IN RJ-45 Connector
Connect to the RJ-45 OUT connector on a transmitter (for example,
TP-580T
).
8
HDMI OUT Connector
Connect to an HDMI acceptor.
9
AUDIO
OUT
S/PDIF RCA Connector
Connect to a digital stereo audio acceptor.
10
ANALOG 3.5mm Mini Jack
Connect to an analog unbalanced stereo audio acceptor.
11
IR 3.5mm Mini Jack Connector
Connect to an external infrared emitter / sensor.
12
RS-232 3-pin Terminal Block Connector
Connect to a controlled device (so that it can be controlled from a remote serial controller);
connect to a laptop to upgrade the firmware or to a control system to serially control the
TP-580RA
.
13
12V DC Power Connector
12V DC connector for powering the unit.
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
Step 3: Mount TP-580RA
Install
TP-580RA
using one of the following methods:
•
Attach the rubber feet and place the unit on a flat surface.
•
Fasten a bracket on each side of the unit and attach it to a flat surface
www.kramerav.com/downloads/TP-580RA
•
Mount the unit in a rack using the recommended rack adapter
www.kramerav.com/product/TP-580RA
•
Ensure that the environment (e.g., maximum ambient temperature &
air flow) is compatible for the device.
•
Avoid uneven mechanical loading.
•
Appropriate consideration of equipment nameplate ratings should be
used for avoiding overloading of the circuits.
•
Reliable earthing of rack-mounted equipment should be maintained.
