Kramer AFM-20DSP-AEC, Quick Start Manual

Page: 1 / 4

AFM-20DSP-AEC Quick Start
P/N: 2 9 0 0 - 3 0 1 4 8 6 QS Rev: 1
Scan for full manual
AFM-20DSP-AEC Quick Start Guide
This guide helps you install and use your AFM-20DSP-AEC for the first time.
Go to www.kramerav.com/downloads/AFM-20DSP-AEC to download the latest user manual and check if
firmware upgrades are available.
Step 1: Check
what’s in the box
AFM-20DSP-AEC 20 Port Audio Matrix
1 Set of rack ears 1 Quick Start guide
1 Power cord 4 Rubber feet
Step 2: Get to know your AFM-20DSP-AEC
# Feature Function
1 STATUS LED Indicates the system
’s status:
•
3 cycles of red/blue/off/green LEDs
that flash in sequence for 30 seconds
when the system starts up, and the
application has not been launched.
•
Flashes green when the application starts.
•
Stays green when system is ready for use.
2 PORTS LEDs (1 to 20) Indicate the port
’s status:
•
Green when an input signal is
detected, and the port is defined as
line in.
•
White when defined as line out.
•
Blue when defined as mic in.
•
Red when in clipping state.
•
Yellow when in limiting state.
•
Off when there is no signal on the input.
3
IN OUT Dante
™ LEDs
(1 to 4)
Indicate the Dante
’s signal status:
•
Green when a signal is detected.
•
Red when clipping occurs.
•
Yellow when in limiting state.
•
Off when no signal is detected.
4
HDMI™ LEDs
EMBED Turns green when an analog audio signal is associated with the HDMI OUT signal.
Otherwise, it stays OFF.
DE-EMBED Turns green when the HDMI IN audio signal is detected. Otherwise, it stays OFF.
5 IN OUT USB or S/PDIF LEDs Indicate the USB or S/PDIF
’s status:
•
Green when a signal is detected.
•
Off when no signal is detected.
If a signal is detected on one channel, either left only or right only, the status LED is
green.
6
CH 1(L)/CH 2(R) AMPLIFIER
LEDs
Indicate the amplifier
’s signal status:
•
Green when a signal is detected.
•
Off when no signal is detected.
On the web page, CH1 and CH2 are referred to as AMP 1 and AMP 2, respectively.