675R/T
Quick Start
P/N: 2 9 0 0 - 3 0 1 3 8 9 QS
Rev: 1
Scan for full manual
675R/T Kit Quick Start Guide
This guide helps you install and use your
675R/T
for the first time.
Go to
www.kramerav.com/downloads/675R/T
to download the latest user manual and check if firmware
upgrades are available.
Step 1:
Check what’s in the box
675T
HDMI Optical Transmitter
2 Power adapters and cords
1 Quick start guide
675R
HDMI Optical Receiver
8 Rubber feet
2 Bracket sets
2
OSP-MM1
Fiber Optic SFP+ Transceivers
Step 2: Get to know your 675R/T
675T
#
Feature
Function
1
IN LED
Lights green when a connected source device (with an active HDMI signal) is
detected.
Flashes 4 times green when resetting the device.
Off when a connected source device with an active signal is not detected.
2
OUT LED
Lights green when both a connected HDMI source (with an active HDMI signal) and
a connected far-end HDMI acceptor are detected.
Off if either the source or the acceptor is not connected, or an active signal is not
present.
3
LINK Tx and Rx LEDs
Light green when OUT IN SFP+ is connected and an active optical link is detected.
Light red when OUT IN SFP+ is connected, but an active optical link is not detected.
Off when OUT IN SFP+ is disconnected.
4
ON
LED
Lights green when the device receives power.
5
HDMI™ IN Connector
Connect to an HDMI source.
6
OUT IN
SFP+ Connector
Connect the fiber optic cable to the plugged-in SFP+ optical module connector.
7
RESET Recessed Button
Press and hold to reset settings to factory default values.
8
SERVICE Micro USB Port
Connect to a PC to perform firmware upgrade (via K-Upload).
9
12V DC Power Connector
12V DC connector for powering the unit.
