FIREPLACE SETUP
27
SP-41-L MANUAL REV#2 OCT 2017
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
8.0 FIREPLACE SETUP
8.1 Safety Barrier Installation
8.1.1 Safety Barrier Screen (#SP41-SCR)
1. Locate the (4) slots located on each side of the fireplace
frame.
2. Align the notched tabs located on the back of the safety
screen with the slots on the fireplace frame.
3. Raise the safety screen front slightly into slots and allow the
tabs to lower into position.
• To remove safety screen: lift the screen up and out of slots.
8.1.2 Overlay Designs (#SP41-
POL & #SP41A-POL)
1. If installed, remove the safety barrier screen.
2. Center the overlay over the safety screen.
3. Locate the (4) tabs on the overlay. Hand bend tabs to secure
the overlay to the safety screen front.
4. Locate the (4) slots located on each side of the fireplace
frame.
5. Align the notched tabs located on the back of the safety
screen with the slots on the fireplace frame.
6. Raise the safety barrier slightly into slots and allow the tabs
to lower into position.
• To remove safety barrier: lift the screen up and out of slots.
8.2 Glass Frame Assembly
WARNING: Do not operate this fireplace with the glass removed,
cracked, or broken. Replacement of the glass assembly should
be done by a licensed or qualified service person.
8.2.1 Remove Glass Frame Assembly
WARNING: Do not remove the glass assembly when hot.
1. Remove the safety barrier and open the control compartment
access panel.
2. Locate (2) spring-loaded latches securing the glass assembly
at the bottom of the fireplace.
3. Pull the spring-loaded latches out and down to release the
bottom of the glass assembly.
4. Lift glass assembly up and off of the (2) tabs located at the
top of the firebox.
8.2.2 Install Glass Frame Assembly
1. Align the slots on top of the glass assembly over the tabs
at the top of the firebox while lowering the bottom of the
assembly into position.
2. Pull the spring-loaded latches out and up to secure assembly
bottom of the fireplace.
3. Set the control compartment back into position and reinstall
safety barrier.
Figure 8.1, Safety Barrier Installation
