Ins talla tio n
20
Operating manual for PROFIBUS fieldbus | DOC01185928-0008 | 2016-12 | V1.8 EN
3.2
INVEOR bus address
DANGER!
Risk of death due to electrical shock!
Death or serious injury!
De-energise drive controller and secure it against being restarted.
In order that an INVEOR, equipped with a PROFIBUS communication card, can be clearly
recognised in a PROFIBUS system, it must be assigned an address. The assignment can take
place:
By setting the address via the rotary switches "Switch 1" and "Switch 2" found on the printed
circuit board (PCB).
By setting the parameter 6.060 "Fieldbus address"
(see chapter "Parameter list“ of the operating manual)
Use INVEORpc, MMI or PROFIBUS master for parameterisation.
Fig.: 9 Setting parameters via rotary switches"
Switch 1 – for the unit position
Switch 2 – for the tens position