Kostal INVEOR M, Operating Manual, Page: 19 / 51

Dev ice and s y s tem des cri ptio n
18 Operating manual for PROFIBUS fieldbus | DOC01185928-0008 | 2016-12 | V1.8 EN
2.4.2 Pin assignment for interfaces
Pin assignment on device side of M12 socket for PROFIBUS
:
PIN no. Signal
1 + 5 V DC
2 RxD/TxD-N / A-line (green)
3 Ground
4 RxD/TxD-P / B-line (red)
5 Not used
Housing Shielding
Fig. 8: Round plug connector, 5-pin, M12, B-coded for PROFIBUS fieldbus
2.4.3 Cable
The following points should be observed when wiring:

Lay bus and power cables as far apart as possible (min. 30 cm).

If cables do cross, an angle of 90° should be observed if possible.
2.5 Software components
What software do I require to operate and configure the drive controller with PROFIBUS.
The INVEOR drive controller can be parameterised using the INVEORpc tool and MMI
(see operating manual) as well as the PROFIBUS master.