Location of Controls
RADIO DISPL
RADIO DISPL
RADIO DISPL
RADIO DISPL
RADIO DISPL A
A
A
A
AYYYYY
14. AM/FM INDICATOR
15. STEREO INDICATOR
16. RADIO FREQUENCY
17. MEMORY INDICATOR
18. MEMORY CHANNEL INDICATOR
19. LOCK INDICATOR
TIME DISPL
TIME DISPL
TIME DISPL
TIME DISPL
TIME DISPL A
A
A
A
AYYYYY
20. AM/PM INDICATOR
21. HOUR AND MINUTE
Location of Controls
1. LOCK ON/OFF SWITCH
2. HEADPHONES JACK
3. TUNE DOWN / TIME SET MINUTE BUTTON
4. TUNE UP / TIME SET HOUR BUTTON
5. MEMORY UP / DOWN BUTTON
6. TIME / MEMORY BUTTON
7. BAND BUTTON
8. LCD DISPLAY
9. BATTERY COMPARTMENT
10. VOLUME CONTROL
11. POWER ON/OFF SWITCH
12. BBS ON/OFF SWITCH
13. BELT CLIP
7
77
77
3
33
33
5
55
55
6
66
66
4
44
44
Battery Installation
1. Hold the radio upside down and slide the battery
compartment door in the direction of the arrow until
the door pops open.
2. Insert two "AAA" size battery (not included), following
the polarity diagram shown on back of the unit. We
recommend using alkaline batteries for longest life.
3. Push the battery compartment door closed and slide
it back opposite the direction of the arrow.
2
22
22
Using the Belt Clip
With the supplied Belt Clip, you can wear your
unit on a belt for convenient use.
1. Attaching the Belt Clip.
2. Removing the Belt Clip.
1
11
11
Memory Backup
In order to maintain the memories when installing new
batteries, the unit must be turned off and new batteries
installed within 30 seconds.
NOTE:
Sometimes, erratic information may appear on the LCD display
when batteries are changed. In order to reset the unit, remove
the batteries and install batteries after waiting for 5 minutes.
The memories and current time must be reset.
Using Wrist Strap
1. Insert strap and loop through.
2. Pull and tight up the strap.
Listening to the Radio
1. Set the Power ON/OFF switch to ON position.
2. Select the FM or AM band by pressing the Band button.
The FM and AM bands are alternately selected each
time when the band button is pressed.
3. Insert the headphones plug into the headphones jack.
4. Press the TUNE button.
Higher frequency can be selected by pressing the
UP button and lower frequency by DOWN button.
Pressing either button and holding for more than 1
second activates the automatic tuning mode and
stops automatically when a broadcasting band is
found.
The automatic tuning will continue to scan even
after the search reaches either of the band edges
(max. frequency or min. frequency). Once the
search reaches max. frequency, it will return to
min. frequency and continue to search upwards.
Press the TUNE button again to select the desired
band.
5. Adjust the VOLUME controls, as desired.
