Korg TRITON Extreme, Manual

Page: 43 / 354

32
BUS Sel. (BUS Select)
[L/R, 1, 2, 3(Tube), 4(Tube), 1/2, 3/4(Tube), Off]
Specifies the bus to which the sound will be sent after pass-
ing through the insert effect. Normally you will set this to L/
R
. If you wish to output to AUDIO OUTPUT (INDIVID-
UAL), set this to 1, 2, 3(Tube), 4(Tube), 1/2, or 3/4(Tube). The
Off
setting is used when you wish to use “Send 1” and
“Send 2” and in addition connect to the master effects in
series.
If you want to insert Valve Force after the sound has
passed through an insert effect, select 3/4(Tube),
3(Tube)
, or 4(Tube). Set the Valve Force “Placement”
(9–5a) to Insert.
Send1 [000...127]
Send2 [000...127]
Sets the send levels to the master effects 1 and 2 for the
sound that has passed through the insert effect. These set-
tings are valid when “BUS Select” (8–2a) has been set to L/R
or Off.
Control change CC#93 will control the Send 1 level, and
control change CC#91 will control the Send 2 level.
These messages are received on the global MIDI chan-
nel specified by “MIDI Channel” (Global P1: 1–1a).
8–3: IFX 1
8–4: IFX 2
8–5: IFX 3
8–6: IFX 4
8–7: IFX 5
Here you can set the effect parameters for the IFX 1/2/3/4/
5 that were selected in the Insert FX page (
☞
p.217–).
Effect dynamic modulation (Dmod) is controlled on the
global MIDI channel “MIDI Channel” (Global P1: 1–1a).
(“D.mod”
☞
p.277)
☞
For details on the master effects, refer to p.205 “8. Effect
Guide.”
9–1: Master FX
Here you can select the master effect types, switch them on/
off, specify chain order, and set the master EQ.
9–1a: MFX1, 2
The master effects do not output the direct sound (Dry). The
return level (“Return1,” “Return2”) sends the effect sound
(Wet) to the L and R bus, and this is mixed with the direct
sound (i.e., the output from P8: Routing tab “BUS Select” L/
R
, or the L/R output from Insert FX page “BUS Select”).
The master effects have a mono input. After passing through
the oscillator and insert effects, sound that is panned L and
R is mixed to a mono signal (as adjusted by the “Send 1” and
“Send 2” levels) and input to the master effects.
The master effects are mono-in stereo-out. Even when
a stereo-input type effect is selected, the input will be
monaural.
MFX1, 2 [000...089]
Selects the effect type for master effect 1 and 2. You can
select from 90 types of effect: 000: No Effect–089: Reverb-
Gate
. (Double-size effects cannot be selected.) If 000: No
Effect is selected, the output from the master effect will be
muted.
Category/MFX Select menu:
When you press the popup button, a “Category/MFX
Select” menu will appear. Press a tab to select the desired
category of effect, and select an effect from the list. Press the
OK button
to execute, or press the Cancel button to cancel.
0–1
Program P9: Edit–Master Effect
9–1
9–1c
9–1a
9–1b