Output Routing - Trinity Series
NOTE: this tutorial is actually in two parts. The method for routing to outputs 3 and 4 varies if a
track contains insert effects, which is covered in the latter part of the tutorial. Also note that in order
to reroute outputs 3 and 4, all master effects need to be shut off, and returns for those effects both
need to be set to 0.
First, you need to separate the 3
rd
and 4
th
outputs:
1.
Press the SEQ button to enter the sequencer mode.
2.
Press the P8 button to enter the Master Effects page.
3.
Touch the box labeled "Pan 2".
4.
Using the value slider, wheel or buttons, set the parameter in that box to "R".
For a track (tracks) that you wish to reroute to either 3 or 4:
1.
Press the P1 button to enter the main sequencer page.
2.
Touch the "Pan" icon.
3.
Using the value slider, wheel or buttons, set the pan parameter to "Off". This will stop the sound from
being heard on the 1
st
or 2
nd
output.
4.
Touch the "Mix…" tab on the bottom of the screen.
You will see 2 sets of "000" for each track. One represents the value for Send 1 and the other is Send
2. These sends are used to reroute the sound to the 3
rd
and 4
th
outputs. Send 1 controls the amount of
signal for output 3 and Send 2 controls the amount of signal for output 4.
5.
Touch either the "000" for Send 1 or Send 2 (depending on which output you want the sound for that
track routed).
6.
Using the value slider, wheel or buttons, set the parameter to any number other than "000". The higher
you set it, the more volume you will hear.
If the track contains INSERT EFFECTS:
1.
Press the SEQ button to enter the Sequencer mode.
2.
Follow the first set of directions for separating the 3
rd
and 4
th
outputs.
Output Routing for the Trinity Series (Continued)
3.
Press the P7 to enter the Effect Grouping page.
For a track (tracks) that you wish to reroute to either 3 or 4:
4.
Touch the effect parameters for that track.
