STAGEMAN 80 Owner's manual
12
Turning the power on/off
The STAGEMAN 80 can use either an AC adapter or batteries.
Using the AC adapter
Use only the included AC adapter. You risk causing a
malfunction if you use any other AC adapter.
1.
Make sure that the power of the STAGEMAN 80 is off.
Check that nothing is shown in the display, and that the
buttons are unlit.
2. Connect the DC plug of the AC adapter to the DC19V
jack located on the rear panel.
Pay attention to the orientation of the jack when making
this connection.
3. Connect the plug of the AC adapter to an AC outlet.
Be sure to use an AC outlet of the correct voltage for the
adapter.
Using batteries
Batteries are not included. You must purchase them
separately.
1.
Remove the battery cover from the rear panel.
2.
Install six D batteries, either alkaline or nickel-metal
hydride, taking care that each battery is oriented in the
correct polarity as shown in the illustration.
3.
In System mode, specify the type of batteries that you’re
using.
See page 25 “[M1] Battery type “batt””
If you switch to using a different type of battery, be sure
to specify the correct battery type in System mode.
Replacing the batteries
Replace the batteries when the power button blinks.
As the batteries run low, you might hear noise or
interruptions in the sound.
Unusable batteries should be removed immediately. If
unusable batteries are left installed in the unit, they may
leak, causing malfunctions. You should also remove the
batteries if you don’t plan to use the unit for an extended
time.
Be sure to replace all six batteries together as a set. Do not
mix fresh batteries with used batteries in the same set.
Turning the power on
Note:
If a device is connected to the AUX IN jack, turn its
power on before you continue.
Note:
If you’re using an SD card, insert it into the SD card
slot before you turn on the power (see page 10 “About SD
cards”).
1.
On the top panel, set the VOLUME knob to the
minimum level (far left).
2.
On the top panel, hold down the power button for at
least one second to make the button light.
When the STAGEMAN 80 finishes starting up, it is ready
to produce sound.
3.
Use the VOLUME knob to adjust the volume.
Turning the power off
Never turn off the power or disconnect the power cord
during recording, while data is being converted, or while
data is being written to the system.
Doing so may make the STAGEMAN 80 malfunction, or
damage the data on the SD card. If the data on the SD card
has been damaged, format the card.
1.
If recording or playback is occurring, press the
[
] button to stop.
2.
Hold down the power button for one second or longer
until the button blinks.
After a time, the power button and display indication will
go dark, and the STAGEMAN 80 will shut down.
Caution when turning the power off andon again!
To turn off the power
of the STAGEMAN 80, you must press
the power button located on the panel. (When you do this, the
STAGEMAN 80 saves its data.)
Wait at least five seconds
before turning the power on again.
Never disconnect the AC adapter or remove the batteries
while the power is on.
If it becomes impossible to turn on the power
because
the cautions described above were not observed correctly,
disconnect the AC adapter, remove the batteries, and wait two
minutes; then reconnect the AC adapter, install the batteries,
and turn the power on.
Summary of Contents for STAGEMAN 80
Page 1: ...EFGSJ 3 ...
Page 2: ......
