Korg SGPROX, Owner'S Manual

Page: 41 / 72

Performance Edit mode
41 41
When TIMBRE A/B is selected
7. ZONE (Keyboard zone settings)
Here you can specify keyboard zones to create splits
and velocity switches.
This setting can be changed using the
〈
VALUE
〉
switches (or slider), or by holding down the
〈
PERF
EDIT
〉
switch and pressing a note on the keyboard.
Split Zone
Range Key Zone Bottom C–1 to G9
Key Zone Top C–1 to G9
Notes in the keyboard area between the Bottom note
and the Top note will sound.
Velocity Zone
Range Vel Zone Bottom 1 to 127
Vel Zone Top 1 to 127
Notes played with a velocity (playing strength)
between the Bottom and Top values will sound.
It is not possible to set the Top value below the Bot-
tom value, nor the Bottom value above the Top value.
8. FILTER (Settings for various
filters)
Damper/Sostenuto
Specifies whether the damper/sostenuto effects will
be applied (ENA) or not (DIS).
Controller
Specifies whether modulation Control such as pitch
bend, vibrato and tremolo will be applied (ENA)
or not (DIS).
Timbre B FX routing
Specifies whether or not the signal from timbre B
will be sent through effect 1( p.50).
When TIMBRE 1 to 8 is selected
7. ZONE (Keyboard zone settings)
Here you can specify the range of the note mes-
sages that will be transmitted.
This setting can be changed using the
〈
VALUE
〉
switches (or slider), or by holding down the
〈
PERF
EDIT
〉
switch and pressing a note on the keyboard.
Split Zone
Range Key Zone Bottom C–1 to G9
Key Zone Top C–1 to G9
Note messages will be transmitted for notes played
in the keyboard area between Bottom and Top notes.
Velocity Zone
Range Vel Zone Bottom 1 to 127
Vel Zone Top 1 to 127
Note messages will be transmitted for notes played
with a velocity (playing strength) between the Bot-
tom and Top values.
It is not possible to set the Top value below the Bot-
tom value, nor the Bottom value above the Top value.
8. FILTER (Settings for various
filters)
You can specify whether or not each of the
SGproX’s controllers will transmit MIDI mes-
sages.( p.55).
A.WHEEL1 DIS, ENA
A.WHEEL2 DIS, ENA
A.SLIDER1 DIS, ENA
A.SLIDER2 DIS, ENA
A.SLIDER3 DIS, ENA
A.SLIDER4 DIS, ENA
A.PEDAL DIS, ENA
A.PEDAL SW DIS, ENA
DAMPER
DIS, ENA
AFT.TOUCH DIS, ENA
When you operate a controller which is set to
“ENA,” the message assigned to that controller will
be transmitted on the MIDI channel of that timbre.
For each controller, refer to
Controllers / MIDI
( p.55).