21
Saving edited effects in a selected destination
You can save (write) your preferred sounds.
If you switch to a different program or turn off the power before saving, the changes you’ve made
will be discarded, and the settings will revert to their original state.
1.
Press the WRITE button. The save destination of the program will blink on the display.
2.
Select the save destination bank with the TAP/BANK UP switch and select the save
destination with the Channel switches A or B.
3.
Press the WRITE button again to start the save function. After the save function is complete
and “CPLt” appears on the display, the program number appears. To cancel, press the EXIT
button.
Do not disconnect the cable from the INPUT (L/MONO) jack while saving an effect.
Overwriting edited effects
1.
Press and hold the foot switch for the currently selected channel. Then, release the foot
switch when “CPLt” appears on the TIME/VALUE display.
The effect settings are saved with the channel for the currently selected bank.
Saving a Program
Summary of Contents for SDD-3000
