6
|
Setting the MIDI channels
Programming the master controller
Match the MIDI channel(s) on which the master controller will send data with
those on which the Pa-Series instrument will receive data.
1
On the master controller, set the MIDI channel(s) on which data will be trans-
mitted. Usually, channel 1 is the default setting (when only a single channel
is transmitted).
2
If the master controller also includes a sound generator, lower its master vol-
ume to zero, to avoid hearing its own sounds. If you want to layer the sounds
of the master controller and the Pa-Series instruments, increase the volume.
As an alternative, you can set it to the Local Off status, to only allow it to play
via MIDI the sounds of the Pa-Series instrument, and not its own.
Please, read the manual of the master controller for instructions on how to
set the various parameters.
Programming the Pa-Series instrument
Configure the MIDI channels on the Pa-Series instrument.
1
Go to the
Global > MIDI
pages.
2
Either choose a MIDI Preset, or manually program the MIDI IN channels.
▪
If a MIDI Preset matching your type of connection exists, go to the
Global
> MIDI > General Controls
page and use the
Midi Preset
pop-up menu to
choose the MIDI Preset.
