Korg Nu:tekt OD-KIT, Owner'S Manual, Page: 3 / 16

- 3 -
Cautions Before Assembly
Be careful of injury when handling parts
Use caution not to injure yourself due to the protruding parts when
handling the circuit board. Use cotton work gloves to protect your hands
when working. Also, be sure to wash your hands thoroughly after working.
Tighten screws and nuts at a perpendicular angle
Tightening screws and nuts that are inserted diagonally may damage the
threads, making it impossible to tighten them again. Be sure to tighten
screws so that they are inserted perpendicular to the surface.
Use caution, as applying too much torque and tightening the screws too
tightly may damage the parts.
Do not injure yourself or scratch the surface with the tools.
When using tools to tighten screws and nuts, make sure not to injure
yourself, such as by getting your fingers pinched. Work carefully to avoid
scratching the case or circuit board with the tools.
Provide a sufficiently large work space to complete the assembly procedure,
and prepare work mats so parts will not be scratched.
Avoid losing the screws and nuts
Handle the screws and nuts with caution, to avoid losing them. Do not use
other screws or nuts aside from the ones included with this kit, and do not
use the screws and nuts included with this kit for any other purpose.
Tools to prepare
You will need the following tools in order to assemble this kit.
Note: You will also need a battery, solder, glue, adhesive tape and so on.
These items are not included, so please obtain them separately.
• Soldering iron
• Nippers, needle-nose pliers, tweezers
• Phillips head screwdriver (No. 2), precision flathead screwdriver (2.4
mm)
Use a screwdriver that matches the size of the screw. Using the wrong
size of screwdriver may damage the screw or make it impossible to
tighten.
• Spanner, wrench (two-sided, 10 mm/11 mm/14 mm wide)
• Tester
Checking the parts
Before assembly, make sure that all parts are on hand.
Contact us at www.nutekt.org if any parts are missing or damaged.
Caution when painting the case
Make sure not to get any paint on the areas on the case that come into
contact with the volume controls.
The case and volume controls should conduct electricity.