Korg Nu:tekt OD-KIT, Owner'S Manual, Page: 14 / 16

- 14 -
Assembly
1. Attach the battery snap [12].
Wrap the wires through the holes on the circuit board and then solder.
Mounting the battery snap in this way will make it more difficult to pull
and break the wires when exchanging the battery. Run the battery snap
side through the hole so that it goes below the main circuit board.
+
（
Red wiring
）
－ （
Black
wiring ）
2. Mount the LED on the upper case [1], and solder the harness (54).
Insert the LED holder [8] into the LED, and snap the end cap on. Attach
the washer and nut from the rear side of the upper case. Solder the
longer LED lead to the red harness wire, and the shorter lead to the
white wire.
Tip: If the end cap is loose and falls off, use adhesive tape or glue to fix it
in place.
3. Attach the foot switch [14] to the upper case [1].
Attach the foot switch so that it is as level as possible with the upper
case, and fix it in place with the washer and nut included with the foot
switch.
4. Mount the main circuit board [18] into the upper case.
Installing the main circuit board into the upper case, attach the jack
washer [16] and temporarily tighten the nut [15].
Attach the washers [7] to the volume controls, and tighten the nuts [6].
Afterwards, tighten the nut [15] of the volume control.
LED Holder
LED
End cap