Korg NAUTILUS Series, Parameter Manual, Page: 684 / 961

GLOBAL mode
674
v 5–1: Page Menu Commands
• Compare → p.112
• Write Drum Kit → p.691
• Copy Key Setup → p.691
• Swap Key Setup → p.691
• PAGE → p.126
• MODE → p.126
5–2: Sample Parameter
Here you can edit the attack and decay, tuning, filter cutoff
and resonance, and three-band EQ settings for each drum
sample. These settings are offsets that are applied to the
settings of the program.
5–2a: Drumsample Parameters
DS1 (High): (Drum Sample 1 High)
DS1(High) On/Off [Off, On]
On (checked): Check this if you want to use DS1 (High).
The selected drum sample will sound.
Off (unchecked): DS1 (High) will not be used. The drum
sample will not sound.
Attack (Amp EG Attack) [–64…+63]
Adjusts the attack time of the volume (Amplifier). The
attack time for each key is determined by adding this value
to the amp EG Attack Time of the Program that uses this
drum kit.
Decay (Amp EG Decay) [–64…+63]
Adjusts the decay time of the volume (Amplifier). The decay
time for each key is determined by adding this value to the
amp EG Decay Time of the Program that uses this drum kit.
Transpose [–64…+63]
Adjusts the pitch in semitone steps.
+12 is one octave up, and –12 is one octave down.
Tune [–99…+99]
This adjusts the pitch in cents, over a range of ±1 octave. A
cent is 1/100 of a semitone.
Drive [–99…+99]
This adjusts the drive level. This offset value for each key
and drum sample is applied to the driver “Drive”
(PROGRAM 4–1a) setting of the programs that use this
drum kit.
Low Boost (Driver Low Boost) [–99…+99]
This adjusts the low boost level of the driver. This low boost
setting for each key and drum sample is applied to the driver
“Low Boost” (PROGRAM 4–1a) setting of the programs
that use this drum kit.
Filter Cutoff [–64…+63]
Adjust the cutoff frequency of the filter. The cutoff
frequency for each key and drum sample is determined by
adding this value to the filter
Frequency (PROGRAM 3–1b)
of the program that uses this drum kit.
Resonance (Filter Resonance) [–64…+63]
This adjusts the filter resonance. This offset value for each
key and drum sample is applied to the filter “Resonance”
(PROGRAM 3–1b) of the programs that use this drum kit.
5–2PMC
5–2b
5–2a