Korg NAUTILUS Series, Parameter Manual, Page: 654 / 961

GLOBAL mode
644
Unloading an entire bank of data
You can also un-load an entire bank of data at once. To do
so:
1. In the menu, select the Unload all in bank command.
The Unload all data from selected bank dialog will appear.
2. Select the desired bank (SAMPLING Mode, or any
EXs or User Sample Bank).
3. Press the OK button to confirm, or Cancel to exit the
dialog without making changes.
Unloading half of a stereo sound
Stereo Samples and Multisamples are made up of two linked
items, one for the left channel and the other for the right
channel, with names ending in -L and -R respectively. The
left and right channels also may be used individually as
mono sounds.
If either the left or right channel is unloaded, the item is
removed from the list of stereo Samples or Multisamples.
However, the remaining channel is still available as a mono
sound.
Change load method
Change load method
This button lets you change how the currently selected
sample data is loaded, using either RAM or Virtual Memory.
Note that this has no effect on the data stored on drive.
If all of the selected samples are too large to fit into RAM,
then the
Load Method combo box will be grayed out, and
the value will be set to Virtual Memory .
This applies only to data in EXs and User Sample Banks; it
does not apply to SAMPLING mode.
Load method [No Change, RAM, Virtual Memory]
No Change : this is the default. The load method of the
sample data will remain as it was before.
RAM : The sample data will be loaded into RAM.
Virtual Memory : The sample data will be loaded using
Virtual Memory.
v 0–4: Page menu commands
• Select All → p.688
• Unload all in bank → p.688
• Remap MS/Sample Banks → p.125
• PAGE → p.126
• MODE → p.126